Chevrolet Equinox Owners Manual: Blizzard Conditions

Chevrolet Equinox Owners Manual / Driving and Operating / Driving Information / Winter Driving / Blizzard Conditions

Stop the vehicle in a safe place and signal for help. Stay with the vehicle unless there is help nearby.

If possible, use Roadside Assistance. See Roadside Assistance Program. To get help and keep everyone in the vehicle safe:

Turn on the hazard warning flashers.
Tie a red cloth to an outside mirror.

Warning Snow can trap engine exhaust under the vehicle. This may cause exhaust gases to get inside. Engine exhaust contains carbon monoxide (CO), which cannot be seen or smelled. It can cause unconsciousness and even death.

If the vehicle is stuck in snow:

Clear snow from the base of the vehicle, especially any blocking the exhaust pipe.
Open a window about 5 cm (2 in) on the vehicle side that is away from the wind, to bring in fresh air.
Fully open the air outlets on or under the instrument panel.
Adjust the climate control system to circulate the air inside the vehicle and set the fan speed to the highest setting. See "Climate Control Systems."

For more information about CO, see Engine Exhaust.

To save fuel, run the engine for short periods to warm the vehicle and then shut the engine off and partially close the window. Moving about to keep warm also helps.

If it takes time for help to arrive, when running the engine, push the accelerator pedal slightly so the engine runs faster than the idle speed. This keeps the battery charged to restart the vehicle and to signal for help with the headlamps.

Do this as little as possible, to save fuel.

Driving on Snow or Ice

Snow or ice between the tires and the road creates less traction or grip, so drive carefully. Wet ice can occur at aboutC (32 F) when freezing rain begins to fall. Avoid driving on wet ice or in ...

If the Vehicle Is Stuck

Slowly and cautiously spin the wheels to free the vehicle when stuck in sand, mud, ice, or snow. If stuck too severely for the traction system to free the vehicle, turn the traction system off ...

Other materials:

Piston, Connecting Rod, and Bearing Installation Engine Block Cylinder Block Piston Assembly
Special ToolsEN 8037 Ring CompressorEN 43690-A Rod Bearing Clearance Checking ToolEN 45059 Angle MeterEN 46121 Connecting Rod Guide Pin SetEN 48589 Crankshaft Rotation SocketFor equivalent regional tools, refer toSpecial Tools.Piston and Connecting Rod Assembly ProcedureLiberally lubricate the cylin ...