Chevrolet Equinox Service Manual: Fastener Tightening Specifications - Transmission Unit Automatic Transmission Unit
Transfer Case Bracket-to-Engine Bolt– Hole 4 | 50-Y | 37-lb-ft |
Transfer Case Bracket-to-Engine Bolts– Holes 1, 2, and 3 | 23-Y | 17-lb-ft |
Transfer Case Bracket-to-Transfer CaseBolts – Holes 5 and 6 | 50-Y | 37-lb-ft |
Transfer Case Drain Plug | 39-Y | 29-lb-ft |
Transfer Case Fill Plug | 39-Y | 29-lb-ft |
Transfer Case Half Bolts (Qty: 12) | 29-Y | 21-lb-ft |
Transfer Case Heat Shield Bolts (Qty: 3) | 11-Y | 97-lb-in |
Transfer Case Rear Output Drive Gear Nut (Qty: 1) | 235-Y | 173-lb-ft |
Transfer Case Rear Output Drive Shaft Housing Bolts (Qty:6) | 29-Y | 21-lb-ft |
Fastener Tightening Specifications (On Vehicle) Automatic Transmission Unit
Fastener Tightening SpecificationsApplicationSpecificationMetricEnglishControl Valve Body Bolts12-Y106-lb-inControl Valve Body Cover Bolts12-Y106-lb-inControl Valve Body Cover Studs12-Y106-lb-inDrain ...
Fluid Passages Automatic Transmission Unit
Figure 1: Control Solenoid (w/Body and TCM) Valve AssemblyFigure 2: Control Valve Channel Upper Plate AssemblyFigure 3: Control Valve Channel Plate - Upper Plate SideFigure 4: Control Valve Channel Pl ...
Other materials:
Balance Shaft Removal Engine Block Cylinder Block Balance Shaft
Note:This procedure is not used in Europe.Special Tools EN-43650 Balancer Shaft Bearing Remover and InstallerFor equivalent regional tools, refer toSpecial Tools.Remove the balance shaft bearing carrier bolts.Note:It is possible to install the intake side balance shaft into the exhaust side andvice ...
