Chevrolet Equinox Owners Manual: Universal Remote System Operation
Using the Universal Remote System
Press and hold the appropriate Universal Remote system button for at least one-half second. The indicator light will come on while the signal is being transmitted.
Erasing Universal Remote System Buttons
Erase all programmed buttons when vehicle ownership is terminated.
To erase:
- Press and hold the two outside buttons until the indicator light begins to flash. This should take about 10 seconds.
- Release both buttons.
Reprogramming a Single Universal Remote System Button
To reprogram any of the system buttons:
- Press and hold any one of the buttons. Do not release the button.
- The indicator light will begin to flash after 20 seconds. Without releasing the button, proceed with Step 1 under "Programming the Universal Remote System."
Radio Signals for Some Gate
Operators
For questions or programming help
call 01-800-466-0811 or see
www.homelink.com.
Some gate operators require
transmitter signals to time out or quit
after several seconds of
transmission. This ...
Lighting
...
Other materials:
Fuel Pump Replacement Engine Control
Special Tools EN-48896 High Pressure Fuel Pump Installation Alignment GaugeFor equivalent regional tools, refer toSpecial Tools.Removal ProcedureRelieve the low and high side fuel system pressure. Refer toFuel Pressure Relief.Remove thermostat housing. Refer toEngine Coolant Thermostat Replacement.D ...
