Chevrolet Equinox Owners Manual: Window Automatic Reversal System
The express-close feature will reverse window movement if it comes in contact with an object.
Extreme cold or ice could cause the window to auto-reverse. The window will operate normally after the object or condition is removed.
Automatic Reversal System Override
| Warning
If automatic reversal system
override is active, the window will
not reverse automatically. You or
others could be injured and the
window could be damaged. Before using automatic reversal system override, make sure that all people and obstructions are clear of the window path. |
When the engine is on, override the automatic reversal system by pulling and holding the window switch if conditions prevent it from closing.
Programming the Power Windows
Programming may be necessary if the vehicle's battery has been disconnected or discharged. If the window is unable to express-up, program the window:
- Close all doors.
- Turn the ignition on or to ACC/ ACCESSORY.
- Partially open the window to be programmed, then close it and continue to pull the switch briefly after the window has fully closed.
- Open the window and continue to press the switch briefly after the window has fully opened.
Remote Window Operation
If equipped, this feature allows all the windows to be opened remotely.
If enabled in vehicle personalization,
press and hold 
on the RKE
transmitter. See Vehicle
Personalization.
Window Lockout
This feature stops the rear door
passenger window switches from
working.
Pressto engage the rear
window lockout feature. The
indicator light is on when engaged.
Pressagain to disengage.
...
Sun Visors
Pull the sun visor down to block
glare. Detach the sun visor from the
center mount to pivot to the side
window or, if equipped, extend
along the rod. ...
Other materials:
Fuel Pump Installation Fuel System Fuel Pumps
Special Tools EN 48896 HP Fuel Pump Installation Alignment GaugeFor equivalent regional tools, refer toSpecial Tools.Note:The camshaft must be in the base circle position before the high pressure fuel pumpis installed.Use the EN 48896 alignment gauge-(2) to ensure that the camshaft lobe is in the ba ...
