Caution:The compressor hose must maintain a minimum clearance of20-mm (0.8-in) from the exhaust gasrecirculation (EGR) pipe. If this minimum clearance is notmaintained, damage to the compressor hose may result.
Component Fastener Tightening Caution
Pipe Wrench Positioning CautionBalance Shaft Installation Engine Block Cylinder Block Balance Shaft
Note:This procedure is not used in Europe.Special Tools EN-43650 Balance Shaft Bushing Remover/InstallerFor equivalent regional tools, refer toSpecial Tools.Install the balance shaft bushing using the EN-43650 installer-(1).Seat the balance shaft bushing into the bore using the EN-43650 installer-(1 ...