Chevrolet Equinox Service Manual: Brake Pressure Modulator Valve Pressure Sensor Calibration Dynamics Control ABS Control

Chevrolet Equinox Service Manual / Chassis / Brake Control and Vehicle Dynamics / Brake Pressure Modulator Valve Pressure Sensor Calibration Dynamics Control ABS Control

The brake pressure sensor does not require calibration often.Calibration of the brake pressure sensor might be required aftercertain service procedures are performed. Some of these proceduresare as follows:

Electronic brake control module (EBCM) replacementBrake pressure modulator valve assembly replacement

The Brake Pressure Sensor Calibration procedure can becompleted with a scan tool using the following steps:

Apply the parking brake, or set the transmission in the Pposition.Release the brake pedal.Install the scan tool to the data link connector.Ignition ON, engine OFFSelect Brake Pressure Sensor Calibration in the EBCMConfiguration/Reset Functions list.Follow the scan tool directions to complete the calibrationprocedure.Clear any DTCs that may be set.

Electronic Brake Control Module Scan Tool Information Dynamics Control ABS Control

Table 1: Electronic Brake Control Module Scan Tool DataParametersTable 2: Electronic Brake Control Module Scan Tool OutputControlsThe electronic brake control module (EBCM) scan tool dataparameters li ...

Steering Angle Sensor Centering Sensors Steering Angle Sensor

The steering angle sensor does not require centering often. Centering of the steeringangle sensor might be required after certain service procedures are performed. Someof these procedures are as follo ...

Other materials:

Oil Pan Cleaning and Inspection Engine Lubrication Oil Sump/Pan
Special Tools EN 28410 Gasket RemoverFor equivalent regional tools, refer toSpecial ToolsCleaning ProcedureRemove any old thread sealant, gasket material or sealant using EN 28410 remover.Clean the oil pan and oil pan components in solvent.Clean out debris from the bolt holes.Warning:Refer toSafety ...